Refer to the exhibit. Which statement correctly describes how Router1 processes an FTP request that enters interface s0/0/0 and is destined for an FTP server at IP address 192.168.1.5?

Navigate

Top 100

About

http://learn-ccna.com

Just another WordPress site

Education | Popularity: 0 | Entries: 85 | Modified: 672d 14h ago |

Refer to the exhibit. Which statement correctly describes how Router1 processes an FTP request that enters interface s0/0/0 and is destined for an FTP server at IP address 192.168.1.5?

June 13th, 2010

The router matches the incoming packet to the statement that was created by the access-list 101 permit ip any 192.168.1.0 0.0.0.255 command and allows the packet into the router.

More from http://learn-ccna.com

100 Most Recent Entries

what are two reasons that a network administrator wold use access lists? (Choose two.) 11 Jun 10

CCNA E1 Module 1 10 Dec 3

CCNA Discovery 1 Module 1 Exam Answers Version 4.0 10 Dec 3

Which three VTP parameters must be identical on all switches to participate in the same VTP domain? (Choose three.) 10 Jun 17

Refer to the exhibit. All switches in the network participate in the same VTP domain. What happens when the new switch SW2 with a default configuration and revision number of 0 is inserted in the existing VTP domain Lab Network? 10 Jun 17

Refer to the exhibit. Switch S1 is in VTP server mode. Switches S2 and S3 are in client mode. An administrator accidentally disconnects the cable from F0/1 on S2. What will the effect be? 10 Jun 17

Which two statements are true about the implementation of VTP? (Choose two.) 10 Jun 17

CCNA 2 – Module 11 10 Jun 17

Refer to the exhibit. Which statement correctly describes how Router1 processes an FTP request that enters interface s0/0/0 and is destined for an FTP server at IP address 192.168.1.5? 10 Jun 13

Refer to the exhibit. Which statement is true about the CSU/DSU device? 10 Jun 13

Refer to the exhibit. From the output of the show interfaces and ping commands, at which layer of the OSI model is a fault indicated? 10 Jun 13

Refer to the exhibit. A network administrator is trying to backup the IOS software on R1 to the TFTP server. He receives the error message that is shown in the exhibit, and cannot ping the TFTP server from R1. What is an action that can help to isolate th 10 Jun 13

Refer to the exhibit. Router1 is not able to communicate with its peer that is connected to this interface. Based on the output as shown, what is the most likely cause? 10 Jun 13

CCNA 3 – Chapter 4 10 Jun 13

A technician is talking to a colleague at a rival company and comparing DSL transfer rates between the two companies. Both companies are in the same city, use the same service provider, and have the same rate/service plan. What is the explanation for why 10 Jun 13

Refer to the exhibit. What is placed in the address field in the header of a frame that will travel from the DC router to the Orlando router? 10 Jun 13

When NAT is in use, what is used to determine the addresses that can be translated on a Cisco router? 10 Jun 13

A network administrator is tasked with maintaining two remote locations in the same city. Both locations use the same service provider and have the same service plan for DSL service. When comparing download rates, it is noticed that the location on the Ea 10 Jun 13

What are the symptoms when the s0/0/0 interface on a router is attached to an operational CSU/DSU that is generating a clock signal, but the far end router on the point-to-point link has not been activated? 10 Jun 13

A technician has been asked to run Cisco SDM one-step lockdown on the router of a customer. What will be the result of this process? 10 Jun 13

Refer to the exhibit. Which statement is true about the Frame Relay connection? 10 Jun 13

Which two statements are true about creating and applying access lists? (Choose two.) 10 Jun 13